Factory Reset

by terminal

Warning

For using this mode you need a UART interface (3,3V level only) to connect Prado to your pc. This interface is not provided.

It can be possible reset to factory defaults module RN-131C through the Pass-Through Mode with the following commands:

  1. Place the mode RN-131C module in command mode
$$$
  1. Reset the module to factory default conditions.
factory R
  1. Reboot the device.
reboot

by hardware

_images/IMG13.jpg

To reset to the factory settings the RN-131C module means hardware you need to follow the following steps:

  1. insert the jumpers J1 and J2
  2. start the demo
  3. take off and put the jumper J2 until the LED3, LED5 do not flash.